All materials on this Website (the "Site"), and the Site itself are protected by copyrights, trademarks and/or other intellectual property rights. These materials are owned by The Metal Arts Guild of Canada ("MAGC") or by the artists who created these materials. View Full Copyright Notice or this network's Terms of Service
Posted by Vuong Le on September 12, 2018 at 11:44pm
Posted by leorno01 on September 12, 2018 at 11:24pm
Posted by brishhanaa Cut on September 11, 2018 at 10:59am
Posted by Joseph S. Mendivil on September 9, 2018 at 7:00am
Posted by jerrylost on September 7, 2018 at 4:14am
I'm a pretty new silver smith! I have just started up a little work bench of my own and I bought the EZ torch. It has been working really well the last few months, but this week the flame has started to surge and sputter. Tonight I was just about to anneal a piece of silver and I went to light the torch, It made a fire ball and the flames fell back running down the handle, I turned off both knobs but the flame didn't go out until I blew it out! so after I was sure the flame was out I disconnected the torch from the propane bottle and noticed there is a goey build up of liquid seeping from both ends of the hose and my tip is clogged! any advice for cleaning properly? I want to make sure I have it cleared out before I try to light it again!
Thank you for any information! I have lots to learn